Emboss Transfer2018.02.07. // News

Emboss transfer is possible because – due to poor mounting box to the clutch. One of the most widespread damage the gearbox, there are knock-Forward. This usually happens under load. So for that to determine the cause breakage, you first need to look closely at the mounting box to the clutch. It may be incorrect or unreliable.

Might help, tightening the screws. The problem persists? – Go on to the very mechanism of shifting. Remove it and carefully examined. Coen Brothers insists that this is the case. If you own the gearshift is defective, you may send it until the end (not completely). The reason may be worn latches, looseness forks, as well as their bending. Also look at the state slides. We look at the spring, if weakened, then the slider will move slowly.

Replace spring. Others including Aksia, offer their opinions as well. If the slide is worn – and then replace it. Even if Now knock the transfer, you need to look at the teeth of the gears. Own teeth wear out slowly. When activated the transfer, the end part wears out the teeth. In consequence of the teeth disappear into the cone. This can lead by knocking out transmission while driving beats transfer

© 2012-2018 My China Star All Rights Reserved